New arduino sketch does not work

[turdusmerula]

When I try to create a new arduino sketch the third page (Provide the Arduino Information.) provides only disabled buttons and thus does not allow to validate the new project.

I tried with a new workspace too but it does not work anymore.

Using plugin version 1.1.7
Eclipse version: Indigo Service Release 1
Build id: 20110916-0149

[jantje]

turdusmerula
you probably have not properly executed step 4.2 of the installation. see http://www.baeyens.it/eclipse/Install.html on what needs to be done.

Best regards
Jantje

[turdusmerula]

Thanx :)

To be true I followed theses steps only once, it was with a 1.0.1 version
as far as I remember. I only done updates until now.
The problem appeared with the 1.3.0 and stayed until now.

I'm going to remove the plugin and reinstall, may be it will be better this
way :)

Regars.
Seb.

[turdusmerula]

Okay, you were right.
With a reinstall and following your steps all works as expected right now.

Thanx :)

[jantje]

No problem