Skip to content
Permalink

Comparing changes

Choose two branches to see what’s changed or to start a new pull request. If you need to, you can also or learn more about diff comparisons.

Open a pull request

Create a new pull request by comparing changes across two branches. If you need to, you can also . Learn more about diff comparisons here.
base repository: MaxPayne86Arduino/meta-arduino
Failed to load repositories. Confirm that selected base ref is valid, then try again.
Loading
base: nanbield
Choose a base ref
...
head repository: MaxPayne86Arduino/meta-arduino
Failed to load repositories. Confirm that selected head ref is valid, then try again.
Loading
compare: emc-pre-compliance
Choose a head ref
Checking mergeability… Don’t worry, you can still create the pull request.
  • 4 commits
  • 1 file changed
  • 1 contributor

Commits on Mar 25, 2025

  1. Disable eth phys, wlan and change from X6 to X4 drive for eMMC signal… 

    …s in high-speed mode
    @MaxPayne86
    MaxPayne86 committed Mar 25, 2025
    Configuration menu
    Copy the full SHA
    1a3d5ab View commit details
    Browse the repository at this point in the history

  2. Re-enable phys and wlan module

    @MaxPayne86
    MaxPayne86 committed Mar 25, 2025
    Configuration menu
    Copy the full SHA
    34f13fa View commit details
    Browse the repository at this point in the history

Commits on Mar 26, 2025

  1. Disabling eth phy

    @MaxPayne86
    MaxPayne86 committed Mar 26, 2025
    Configuration menu
    Copy the full SHA
    5f26fc5 View commit details
    Browse the repository at this point in the history

  2. Re-enable phys, eMMC X6 drive, SDIO WiFi X4 drive

    @MaxPayne86
    MaxPayne86 committed Mar 26, 2025
    Configuration menu
    Copy the full SHA
    f5660b9 View commit details
    Browse the repository at this point in the history
Loading